MIL-V-62008B(AT)
4.5.1.12 Seating check. To determine conformance to 3.4.8 through 3.4.8.4, all seat levers shall be operated and the seats checked throughout their entire functional range. The force required to operate each lever shall be measured with inspection equipment and shall not exceed that specified.
4.5.1.13 Light checks. To determine conformance to 3.4.9.1 and 3.4.9.2, all lights shall be operated during and after the break-in run throughout all stages of operation, and checked for functional requirements.
4.5.1.14 Generator voltage check. To determine conformance to 3.4.9.7, the generator voltage shall be checked for functional requirements.
4.5.1.15 Generator blower motor check. To determine conformance to 3.4.9.8 and engine running at idle, the generator blower motor shall be operated and checked for constant flow of air.
4.5.1.16 Passive driver's night viewer power circuit check. To determine conformance to
3.4.9.9 with the master battery control and passive power switches turned on and vehicle generator supplying specified voltage, (see 3.4.9.7), the voltage output of the passive power pack shall be measured at the loose harness plug using an 80 megaohm load.
4.5.1.17 Slip ring and external communication circuit check. To determine conformance
3.4.9.4 and 3.4.9.15, the slip ring and external communication circuits shall be checked at all points required to assure continuity.
4.5.1.18 Auxiliary outlets. To determine conformance to 3.4.9.5, the OVE trouble light or suitable voltmeter shall be attached to the auxiliary outlets and checked for operation. The light or suitable voltmeter shall be removed and each circuit overloaded to check circuit breaker operation.
4.5.1.19 Searchlight control system check.
4.5.1.19.1 Vehicle and searchlight interface. To determine conformance to 3.4.9.6.1, the searchlight control circuits at the external connector shall be checked by inserting appropriate switching leads and jumper cables at control points. Certified fixtures shall be utilized to verify that mounting attachments for gun mount and control boxes have been installed to applicable drawings.
4.5.1.19.2 Searchlight installed. To determine conformance to 3.4.9.6.2, verify that the main gun has been balanced per 3.6.12.2 and align the gun on 600 meter or equivalent target. Elevate the gun 5 mils and perform the following:
a. With the main control box switch at "local" and beam switch at "compact", actuate the searchlight power switch to "visible" and verify that the searchlight beam can be centered on target.
b. Verify "spread beam" and "passive beam" functions.
30
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business