MIL-V-62008B(AT)
inspection plan are being properly applied and (b) Government product inspection to measure quality of product offered for acceptance. Deviation from the prescribed or agreed-upon procedures that might have an effect upon the quality of the product, will immediately be called to the attention of the contractor. Failure of the contractor to promptly correct deficiencies discovered shall be cause for suspension of acceptance until corrective action has been made or until conformance of product to prescribed criteria has been demonstrated.
4.1.3 Parts and components. Parts, components, assemblies and installations shall be inspected in accordance with the drawings listed on EPL 8736334 and Master list of Supplementary Quality Assurance Provisions 8736334 (see 3.4).
4.1.4 Qualified products and materials. The contractor's inspection records shall be checked to determine contractor conformance to 3.3.1 and 3.3.2.
4.1.5 Classification of inspections.
a. Preproduction and first production (see 4.2). b. Quality conformance inspection (see 4.5).
4.2 Preproduction and first production inspection.
4.2.1 Preproduction inspection. A preproduction vehicle (see 3.1) shall be inspected to ascertain vehicle conformance with the requirements of this specification. Inspection shall be performed at a location approved by the Government. Failure of the preproduction model to comply with any of the requirements specified shall be cause for refusal by the Government to conduct a retest until corrective measures satisfactory to the Government have been taken.
4.2.2 First production inspections.
4.2.2.1 Special process inspection. A special process inspection shall be conducted by the Government representatives during fabrication of the first production vehicle (see 3.2) to evaluate conformance of materials and workmanship with drawing and specification requirements.
4.2.2.1.1 Review and evaluation. Review and evaluation of records for processing procedure, inspection systems, and plan of quality control shall be conducted on the following: material, welding, surface hardening, heat treating, protective finishes, etc.
4.2.2.1.2 Hull and turret inspection. The hull and turret shall be inspected prior to covering the weldments with paint or other pertinent components or assemblies.
4.2.2.2 Complete vehicle inspection. To determine conformance to 3.2, contractor shall perform acceptance and control inspections listed in table VIII on the first completed vehicle. Subsequent to contractor's inspection the Government will inspect the vehicle at the contractor's plant.
23
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business