MIL-V-62008B(AT)
c. At a minimum depression of 5 , the main gun shall be capable of being traversed within the zone from 90 each side of the vehicle rear centerline to
20 each side of vehicle rear centerline by manual control with elevation and traverse power switch off. The traverse shall be accomplished without vehicle
interference.
d. At full depression the main gun shall be traversed at maximum traverse speed within the zone of 90 each side of the vehicle front centerline with elevation and traverse power switch on. The main gun shall automatically elevate outside of this zone so that the traverse is accomplished without vehicle interference.
e. At an elevation of 0 the main gun shall be capable of being traversed within the zone of 90 each side of the vehicle rear centerline with elevation and traverse power switch on. The traverse shall be accomplished without vehicle interference.
3.6.13.12 Gun laying (stationary target, vehicle stationary). From a layoff position tabulated in table III, the average time required for a total of four, eight, or 12 trials to position the gunsight reticle within the borders of a 0.25 mil square target shall not exceed that tabulated in table III. The time for layoff position number three shall be met for an equal number of trials from each of four different quadrants from target. The time of all other layoff positions shall be met for two directions from targets. These requirements shall be met by gunner and commander power and manual controls as stipulated in table III. The results of any series of trials shall not be used in any other series.
Table III Gun laying on stationary target.
Layoff - mils |
Average time - seconds |
|||
Position |
Azimuth |
Elevation depression |
Power controls |
Manual controls |
1 2 3 4 5 |
- 25 25 100 400 |
10 - 10 - - |
2 3 5 5 7 |
2 6 8 |
3.6.13.13 Turret and gun control system operation on slope. When the vehicle is canted or pitched on slopes up to and including 15 turret attitude, the gun control system shall be capable of gun laying on a 0.25 mil stationary target as specified in 3.6.13.12, table III, except time limitation, need not be met. This requirement shall apply only to the gunner power control. The gun control system performance on level terrain shall not be affected in any manner as a result of vehicle operation on slopes. Combat load of simulated equipment may be employed if desired.
15
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business