MIL-DTL-62267B(AT)
3.6.4 Engine manifold heater. The wiring for the engine manifold heater shall provide a
switch-actuated chassis battery circuit to the engine. Operation of the pushbutton switch on the
purge pump handle, with the starter switch depressed, shall provide chassis battery voltage to pin
"a" of the multiple connector at the engine electrical quick disconnect (see 4.5.2).
3.6.5 Communications system power supply. Provisions shall be made through a mating
connector to supply power to the communications system from the hull electrical system
(see 4.5.2).
3.7 Fluid Systems.
3.7.1 Hydraulic system. Provisions shall be made to assure internal cleanliness of the
chassis hydraulic system. Hydraulic lines and connections shall be free from leakage in excess of a
seep (see 6.5).
3.7.2 Fuel System. Provisions shall be made to assure internal cleanliness of the fuel
system prior to initial fueling. Fuel system shall be free from leaks (see 4.5.2).
3.7.3 Fuel tanks (rapid fill). Fuel tanks shall be capable of receiving 50 gallons (gal)
(190 liters (L)) of fuel per minute (see 4.5.2).
3.8 Operator's protection. Noise hazard caution signs shall be posted in all crew stations.
The signs shall be clearly visible to all personnel (see 4.5.2).
3.9 Painting, marking, and data plates.
3.9.1 Painting. Unless otherwise specified (see 6.2), chassis exterior paint shall be forest
green camouflage, lusterless, alkyd enamel conforming to MIL-C-46168. The engine
compartment shall be gloss white, matching color chip 17875 of FED-STD-595. The crew
compartment shall be semigloss green, matching color chip 24533 of FED-STD-595. All sliding
parts and operating contact surfaces shall be free of paint (see 4.5.2).
3.9.2 Marking. Marking paint shall be lusterless black, matching color chip 37038 of
FED-STD-595 (see 4.5.2).
3.9.3 Identification and data plates. All plates shall be in accordance with applicable
drawings (see 4.5.2)
3.10 Workmanship. All parts, components and assemblies of the chassis shall be clean
and free from sand, dirt, fins, pits, cracks, sprues, scales, flux and other harmful extraneous
materials and defects. External surfaces shall be free from burrs, sharp edges and corners except
10
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business