MIL-T-62222(AT)
3.5.3.2 Nylon ballistic shield. The gun mount with coaxial machine gun mount, machine gun, spent brass and link ejection bag, sighting system and the nylon ballistic shield installed, shall elevate to a minimum of 19 degrees and a minimum of 8 degrees depression. No binding shall exist between the machine gun, the sighting system and the nylon ballistic shield, to cause the coaxial machine gun to deflect by more than 0.5 mil and the telescope to deflect more than 0.1 mil (see 4.6.17.3.2).
3.5.3.3 System backlash. With the elevation and traverse power switch on or off, the control system backlash shall not exceed 1 mil in traverse and 1 mil in elevation when a perpendicular force of 70 lb is applied in the plane of rotation at a point approximately 20 inches from the muzzle end of the gun. (The backlash shall be that angular movement of the gun in traverse and elevation when the force at the end of the gun is reversed and applied in an opposite direction.) (See 4.6.17.3.3).
3.5.3.4 Turret and gun control system. Except as otherwise specified, the turret and gun control system shall operate and meet all requirements specified herein for the following operating conditions (see 4.6.17.3.4):
a. The turret shall be level within one degree.
b. The vehicle electrical system shall supply at least 25.8 V dc to the turret and gun control system with the engine operating and the generating system ON.
c. The main armament shall be balanced as specified in 3.5.3.1.
NOTE: The system shall be capable of operating at l8 to 30 V dc.
3.5.3.4.1 Traverse and elevation rates.
3.5.3.4.1.1 Gun elevation speeds. The gun shall be controllable in elevation and depression over a speed range of at least 0.5 mil per second to 71 mils per second (4 degrees per second). The steady speed (after acceleration) shall continuously increase with increasing handle displacement; these requirements apply to both gunner and commander power controls (see 4.6.17.3.4.1.1).
3.5.3.4.1.2 Turret traversing speeds. The turret shall be controllable in traverse at all speeds between 0.5 mil per second, and 400 mils per second. The tracking speed shall range as a minimum from 0.5 mil per second to 65.2 mils per second. At speeds above 65.2 mils per second the turret speed shall increase with increased control handle displacement until maximum velocity of not less than 400 mils per second is reached. The system shall remain stable at all times. These requirements are applicable to both the gunner and commander power controls (see 4.6.17.3.4.1.2).
3.5.3.4.2 Main gun laying and tracking.
3.5.3.4.2.1 Gun laying (stationary target, and vehicle). The average time required to position the periscope reticle within the borders of a .25 mil square target shall not exceed the times listed and the conditions as specified in table IV. The time requirement shall be met for the trials of right and left traverse or elevation and depression. For combined traverse, elevation, and depression layoffs, the time requirements apply to number of trials from each of four directions form target. These
14
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business