MIL-T-45379D(AT)
4.6.2.17.10 Auxiliary outlet. To determine conformance to 3.3.17.10, the BII trouble light or suitable voltmeter shall be attached to the auxiliary outlets and checked for operation. The light or suitable voltmeter shall be removed and each circuit overloaded to check circuit breaker operation.
4.6.2.17.11 Personnel heater. To determine conformance to 3.3.17.11 actuate the HI/LO switch to either position and verify reduced speed blower motor operation. Verify that the indicator lamp on the control panel lights within four minutes of turn-on as an indication of burner ignition. Subsequent to ignition, verify that the blower motor is operating at full speed in both the HI/LO switch positions and that the high heat is generated when the HI/LO switch is in the Hi position and low heat is generated when in the LO position. When the HI/LO switch is turned to the OFF position, verify that the indicator light goes out and the blower motor shuts off within 3.5 minutes.
4.6.2.17.12 Engine smoke generator. To determine conformance to 3.3.17.12, when the engine is equipped with an engine smoke generator, activate the smoke generator switch when the engine is warm and operating at 1600 rpm. Verify that both the right and left exhaust ducts emit white smoke.
4.6.2.18 Communications system. To determine conformance to 3.3.18a, each intercom set shall be functionally inspected to ensure proper operation. To determine conformance to
3.3.18b, when a radio set is specified (see 6.2) the radio set shall be functionally inspected through the AN/VIC-1(V) intercom set to ensure proper operation.
4.6.3 Break-in run. To determine conformance to 3.4, each vehicle shall be lubricated and serviced prior to the break-in run. The run shall be on smooth, level, and hard-surface roads for the distance specified in table III. The vehicle shall be operated in reverse after each division.
4.6.3.1 8-mile road test. To determine conformance to 3.4, each vehicle shall be operated a distance of 8 miles or more by the contractor prior to submitting the vehicle for acceptance tests.
4.6.4 Performance.
4.6.4.1 Vehicle mobility.
4.6.4.2 Power plant and power train. To determine conformance to 3.5.2, the vehicle shall be operated throughout all gear and speed ranges as specified herein and checked for functional requirements. The powertrain, final drives, tracks, suspension system, and controls shall be checked throughout all speed and steering ranges and shall perform as specified.
51
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business